Home / Guides / Blade holder, pressure and depth

Guide

Blade holder, pressure and depth

Cut through the vinyl and just mark the backing. Set the blade depth first, then the pressure.

Blade holder, pressure and depth

The 1KG holder

Every V-Smart ships with the V3-BH1KG/G, a copper coated aluminium high pressure holder for the cutter's 1kg pressure carriage. A ball-point V3-PH swaps in for drawing and layout checks.

Pressure and depth

V-Smart pressure is set digitally from 5g to 1000g. Start low, cut a small test shape, and raise the pressure until the shape weeds cleanly without scoring the backing. If you need a lot of pressure, extend the blade a little and test again.

Thick material

The two level pressure pinch rollers hold thicker material, up to 2mm on normal vinyl. For thicker material many users switch to a 60° blade, see the blade angle notes.